LCD separator

Features:

This a 5 in 1 frame machine, which consist of heated, plate, A-frame separator, vacuum manual separator, glue remover and frame press, Right is the frame press switch, glue remover switch and thermostat, Left is the manual separator switch and thermostat, the first one on the right is the vacuum switch. The second one on the right is the A-frame switch. The left side is the A-frame switch. The Blade groove is used for putting the blade while operating glue removing. The three holes are used for fixing the blade. The Installed upper moulds are I phone 4, I phone 5, I phone 6(5.5) and the I phone 6(4.7).

    

When press the frame of I phone 6(4.7). Install directly, Lock it by the screws of front and back. We also have the lower moulds of Iphone6 (5.5), I phone 6(4.7), I phone 5s, I phone 4. Left mould is for the 5-6.6 inch middle frame, right mould is for the 4.5-5 inch middle frame.

l          Operation steps of Middle frame separation

1, Turn on the switch of heated plate thermostat on the left, then setting the temperature to 80℃.

2,A zip lock bag should be ready in advance, sprinkling the 503 cleaning agent on the assembly, put into the ziplock bag, zipping, then take it out after 5 minutes.

3, heating it on the heated plate about 20 seconds, turn on the corresponding mould switch, press the assembly on the suction mould. After being sucked, separating the middle frame slowly by hand.

l          Operation steps of glue remove

1, Loose the 3 screws of the blade groove, put in the blade and screws it.

2,Turn on the thermostat switch on the right side, setting the temperature to 180℃/

3, Put the sillca gel on the heated plate, after the temperature reached, put into the screen with the flex cable inby.

4, Push the screen, the height of the blade and screen should be the same, and then push the screen to remove the glue.

l          Operation steps of frame press

1, Turn on the thermostat switch on the right mould, setting the temperature to 160℃。

2, Choose a lower mould need to press, put the lower mould into the plate(the groove of mould should be downwards), put the lower mould, align at the upper mould. Then fix the screws behind the lower mould.

3, After installing the frame of screen, put it into the lower mould with the right directing, then put the lower mould into the plate with the right position, push the lower mould, press the upper mould for 6-10 seconds. Take out of frame, frame press is finished.

4, When you press the I phone 6(4.7), it needs to install the iphone6(4.7) upper mould, while installing the upper mould, the home key should be downwards to buckle the upper mould, It can be used after fixing the 2 screws of front and back.

Points:

1, be careful of your hand. The temperature of the heated plate and upper mould are high.

2, Take off the blade while you needn’t remove the glue, to prevent from hurting in other operations.